![]() Input voltage not exceeding 35V Port nameĮNA(ENB) connected to H state will enable MOTORA(MOTORB) IN1(IN3) connected to 5V and IN2(IN4) to GND MOTORA(MOTORB) will move clockwise IN1(IN3) connected to GND and IN2(IN4) to 5V MOTORA(MOTORB) will move Anti-clockwise if you want to control speed you can connect the ENA(ENB) to PWM. Max drive power: 25W (Temperature 75 ?)Įnsure that the positive and negative pole connected to the VMS and GND Logic power output Vss: +5~+7V (internal supply +5V)Ĭontrolling level: Low -0.3V~1.5V, high: 2.3V~VssĮnable signal level: Low -0.3V~1.5V, high: 2.3V~Vss ![]() All driver lines are diode protected from back EMF.Ģ DC motor/ 4 coil dual phrase stepper motor output It is a high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepping motors.Both motors can be driven simultaneously while set to a different speed and direction. It can drive two brushed DC motors or one 4-wire two-phase stepper motor. ![]() ![]() This Dual H-Bridge Motor Driver Shield, which based on H-bridge driver Chip L298N Motor Driver Integrated Circuit, is a usefull module for controlling of robotics and mechanics. DMX-A2-DRV-23 NEMA 17/23 double and triple stack motor options 100mA to 3.0A current setting Flexible 2-500 microstep setting 1 MHz maximum pulse rate. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |